简体中文 English
Professional sheet metal stampings,fabrications,metal weldment,agriculture machine parts and assemble parts manufacturer
Home About US Products Facility News Contact Us Link Sitemap
 
3-Point Hitch
Metal stamping
Metal Fabrication
Tie rod
Welding Parts
Hardware Tools
Tube Fabrication
Tractor parts
Auto parts
Agriculture Machine Parts
Assembly Services
Ningbo Yinzhou Yogo Machine Parts Factory
Tel:0086-574-88473429-606
Fax:0086-574-88067798
E-mail:sales@nbyogo.com
SKYPE: My statusnbyogo
Site:www.nb-stamping.com
Add:LuoChiMiao Industry Park,
Hengxi Town,Yinzhou District,Ningbo China 315131

Home > News

How to repair the trailer jack

Source:未知 Date:2012-5-30 17:42:03 Hit:

many trailers have a jack attached to the tongue that is used to lower and raise the trailer hitch onto the vehicle's hitch receiver. This Trailer jack  is often overlooked, and may sit unused for weeks and even months at a time.

Over the years, the Trailer  jack's internal lubrication loses effectiveness. The Trailer jack becomes stiffer until it finally seizes up completely. At this point, you'll have to take the Trailer jack apart and repair it.

1,Unbolt the jack from the trailer frame and remove it. Some jacks are welded to the trailer; for those, raise the front of the trailer with a taller jack and support it on jack stands to work on the jack. Remove the pin or bolt attaching the jack handle to the body of the jack with pliers or a socket wrench and take the handle off.

2 Slide the interior screw assembly out of the tubular body of the jack. Pull the bearing and washers off the top of the screw assembly and clean them with mineral spirits, then polish with steel wool. Inspect the parts for damage and replace them if necessary.

 
 3, Apply grease liberally to the threads of the screw assembly with a grease gun. Place the thicker of the two washers over the top of the screw assembly, add more grease. Place the the bearing over the thick washer with the open side facing up, apply more grease. Place the thin washer over the bearing and apply a final coat of grease over the washer and handle attachment.

4, Insert the screw assembly into the tubular body of the jack. Slide the handle into position and attach it with the pin or bolt

www.nb-stamping.com

Home | Products| News | About Us | Contact Us | Sitemap(xml) | Tags  
Copyright 2006 - 2013 Ningbo Yinzhou Yogo Machine Parts Factory All rights reserved.